Difference between revisions of "VTube-LASER Videos"
From ATTWiki
(→Video 77: Build Entire Assemblies to SOLIDWORKS) |
|||
Line 23: | Line 23: | ||
====Video 77: Build Entire Assemblies to SOLIDWORKS ==== | ====Video 77: Build Entire Assemblies to SOLIDWORKS ==== | ||
− | This video demonstrates how this version of VTube-LASER can build entire assemblies to SOLIDWORKS for you in less than a minute. | + | This video demonstrates how this version of VTube-LASER can build entire assemblies to SOLIDWORKS for you in less than a minute with the press of a couple of buttons. |
<table width=700> | <table width=700> |
Revision as of 01:07, 30 January 2018
See a complete list of VTube-LASER videos on this page.
|
Version 2.9.3
Video 77: Build Entire Assemblies to SOLIDWORKS
This video demonstrates how this version of VTube-LASER can build entire assemblies to SOLIDWORKS for you in less than a minute with the press of a couple of buttons.
Video 76: Use the Measured Tube Averaging (MTA) Feature for Super Accurate Measurements
This video demonstrates how the MTA feature can measure both sides of the same tube to create a measured tube average for more reliable tube shape calculation.
Arm used in this video: ROMER Absolute Arm 7325SI |
||
Arm used in this video: FARO Quantum S ScanArm |
Other Pages
- See Retired VTube-LASER Videos
- Back to VTube-LASER