Difference between revisions of "VTube-LASER Videos"

From ATTWiki
Jump to: navigation, search
(Version 1.80.1 - December 14, 2012)
(Video Topic: How to Use Hard Point 321 PLP (Plane-Line-Point))
Line 29: Line 29:
 
<tr>
 
<tr>
 
<td width=200>
 
<td width=200>
This video shows how to use the 321 PLP method to align a part.  It describes why you might want to use it in unusual circumstances.
+
This video shows how to use the 321 PLP method to align a part.  It describes reasons to switch to this method of alignment in unusual circumstances.
 
</td>
 
</td>
 
<td width=200>
 
<td width=200>
Line 40: Line 40:
 
</tr>
 
</tr>
 
</table>
 
</table>
 
  
 
===Version 1.80.1 - December 14, 2012===
 
===Version 1.80.1 - December 14, 2012===

Revision as of 22:17, 5 February 2013

Vtube-laser logo.jpg See a complete list of VTube-LASER videos on this page.

Vtube-laser 1 73.jpg

Contents


Vtube-laser video 6inch tube.jpg



Version 1.81.1 - February 5, 2013

Video Topic: How to Use Hard Point 321 PLP (Plane-Line-Point)

This video shows how to use the 321 PLP method to align a part. It describes reasons to switch to this method of alignment in unusual circumstances.

VTube 1.81.1 321PLP Tutorial.jpg

Version 1.80.1 - December 14, 2012

Video Topic: Repeatability Test for Surface-Coated Aluminum

This demonstrates a quick repeatability test of a surface-coated aluminum tube.

Note: This video has no narration.

VTube-STEP 1.80.1 repeatability surfacecoat alum.jpg

Video Topic: Effective End Scans

This demonstrates the different end scan techniques for measuring tube.

We discuss the strengths and weaknesses of the various techniques.

VTube-STEP 1.80.1 endscan.jpg

Version 1.80 - December 8, 2012

Video Topic: Effective highly reflective aluminum scanning

This is a proof-of-concept video for a 1/2" highly reflective aluminum tube. The goal is to demonstrate repeatability better than 300 microns.

The result was a range from 80 to 180 microns (0.003 to 0.007") maximum deviation.

This video also shows the best way to scan a highly reflective tube end - and how to be sure the scan is good.

VTube-STEP 1.80 demoscan almuminum.jpg

Version 1.80 - November 23, 2012

How to extract a tube centerline of demo part 2 with VTube-STEP version 1.80. Note that this part has a 180 degree bend - which requires special steps for import anc calculation.

VTube-STEP 1.80 ImportingSolidModels.jpg

Version 1.76.4 - May 15, 2012

How to measure a straight tube.

How to use Measured tube data to create Master tube data.

Version 1.76.3 - April 2, 2012

How to setup the Scanner Control to measuring tubes with the laser probe.

Version 1.76 - March 15, 2012

Unbending a tube with coping at either end.
(Pro and LASER License Level)

Version 1.75 - February 2012








Older Versions



Other Pages