Difference between revisions of "VTube-LASER Videos"

From ATTWiki
Jump to: navigation, search
(Version 1.80 - December 8, 2012)
(Version 1.80 - December 8, 2012)
Line 24: Line 24:
 
===Version 1.80 - December 8, 2012===
 
===Version 1.80 - December 8, 2012===
  
 +
Effective highly reflective aluminum scannning
 
<table width=600>
 
<table width=600>
  

Revision as of 20:28, 10 December 2012

Vtube-laser logo.jpg See a complete list of VTube-LASER videos on this page.

Vtube-laser 1 73.jpg


Vtube-laser video 6inch tube.jpg



Version 1.80 - December 8, 2012

Effective highly reflective aluminum scannning

This is a proof-of-concept video for a 1/2" highly reflective aluminum tube. The goal is demonstrate repeatability better than 300 microns.

The result was a range from 80 to 180 microns (0.003 to 0.007") maximum deviation.

This video shows the best way to scan a highly reflective tube end - and how to be sure the scan is good.

VTube-STEP 1.80 demoscan almuminum.jpg

Version 1.80 - November 23, 2012

How to extract a tube centerline of demo part 2 with VTube-STEP version 1.80. Note that this part has a 180 degree bend - which requires special steps for import anc calculation.

VTube-STEP 1.80 ImportingSolidModels.jpg

Version 1.76.4 - May 15, 2012

How to measure a straight tube.

How to use Measured tube data to create Master tube data.

Version 1.76.3 - April 2, 2012

How to setup the Scanner Control to measuring tubes with the laser probe.

Version 1.76 - March 15, 2012

Unbending a tube with coping at either end.
(Pro and LASER License Level)

Version 1.75 - February 2012








Older Versions



Other Pages