VTube-LASER End Point Deviations

This page describes how to find the END POINT deviations. Back to VTube-LASER

Three Main End Point Deviations

There are three main end point deviation values calculated during an alignment of the MEASURED to the MASTER tube.

END LENGTH Deviations

The end length deviations are found at the top of the Inspection menu. These deviations show you how much to trim a part to make it fit within the current alignment better.

AFTER-TRIM Deviations

These are found in the first T1 value and the last T2 value in the Tangents grid. These deviations show the expected radial deviation if the tube were trimmed.

Other Pages

• See also VTube Intersection Point Tolerances
• Back to VTube-LASER