Difference between revisions of "VTube-LASER Bender Corrections"

From ATTWiki
Jump to: navigation, search
(Correction Damping)
(Correction Damping)
Line 76: Line 76:
 
<td width=300>
 
<td width=300>
 
VTube-LASER uses a unique correction damping feature for situations were corrections tend to over correct.<br><br>
 
VTube-LASER uses a unique correction damping feature for situations were corrections tend to over correct.<br><br>
We learned the damping algorithm by observing manual corrections in customer applications.   
+
We learned the damping algorithm by observing customers make manual corrections in the unique situation.   
 
</td>
 
</td>
 
<td width=300>
 
<td width=300>

Revision as of 21:36, 29 June 2013

Vtube-laser logo.jpg

Vtube-laser 1.77.3.jpg


Contents


Correcting a Bender

You can see the deviation in this part. The transparent yellow tolerance envelopes indicate that the part is outside of the deviation tolerance allowed (in this case 0.039" or 1 mm).

VTube-LASER can send correction data to benders to steer them into the correction motion to make the correct tube shape.

Vtube-laser tubemodel aligned demo0625.jpg


Bender Setup Screen

VTube-LASER uses the Bender Setup screen to control the values in up to 100 connected benders.

This screen shows data that is a separate part of VTube memory. The data in this screen is the bender data, both before and after correction, and it is kept unchanged unless changed by the operator.

  • The blue columns represent the data at the bender before correction.

  • The orange columns represent the data at the bender after correction.

  • The columns between the blue and orange columns represent the adjustments to the data.

Vtube-laser-bendersetup screen.jpg
Vtube-laser-bendersetup grid.jpg

Bidirectional Communication Controls

With the right protocol at the bender, VTube-LASER can recall data from the bender, and send both setup and correction data to the bender.

  • Operators typically press the "1" button to recall data to be sure the data in the blue columns match the data in the bender.

  • Then they press "2" to send the orange columns to the bender as corrected data.

  • Press "3" to clear the adjustment data after a correction as it should only be used one time.

  • For benders that can't respond to a recall (1 above), they can recalculate the blue columns by clearing and placing the adjustments back into the blue columns automatically.

Vtube-laser-bendesetup bidirectional commmunication.jpg

Correction Damping

VTube-LASER uses a unique correction damping feature for situations were corrections tend to over correct.

We learned the damping algorithm by observing customers make manual corrections in the unique situation.

Vtube-laser-bendersetup damping.jpg

Bender Setup

VTube-LASER can also send setup data to the bender for setup.

The software has several choices for controlling how the data is formatted before sending to the bender.

Vtube-laser-bendersetup newdata.jpg

Other Pages