Difference between revisions of "VTube-LASER - End Scan Diameter Qualification Tolerance"
From ATTWiki
(Created page with "<table> <tr cellpadding=10> <td width=300> 300px End Scan Diameter Qualification Tolerance<br><br> * Back to VTube-LASER </td> <td width=300...") |
Revision as of 20:37, 25 September 2013
|
|
|
| The End Scan tolerance will control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values. |
|
Other End-Scan Information
|
Other Pages
- Back to VTube-LASER
