Difference between revisions of "VTube-LASER - End Scan Diameter Qualification Tolerance"
From ATTWiki
(→Choosing Values) |
|||
Line 12: | Line 12: | ||
</table> | </table> | ||
__NOTOC__ | __NOTOC__ | ||
+ | |||
+ | <h3>This feature is considered obsolete and was removed as of Version 2.9 - November 1, 2017</h3> | ||
=== How the Tolerance Works === | === How the Tolerance Works === |
Latest revision as of 04:35, 1 November 2017
End Scan Diameter Qualification Tolerance
|
This feature is considered obsolete and was removed as of Version 2.9 - November 1, 2017
How the Tolerance Works
The End Scan tolerance allows VTube-LASER to control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values. The image illustrates a tolerance of 1 inch. Any end scan points within that region will be qualified (the orange points).The red points are outside the tolerance, so they are rejected. |
How to Set the Tolerance
You can set the tolerance in two places in VTube. One place is in the System Options / Measure 2 menu. |
The second place to edit the value is in the VTube-LASER Measure Setup menu's "Other" tab menu. |
Choosing Values
|
Set the Default
Set the default value by clearing the VTube project, then changing the value, then saving the setup to the default file in the System Options - Project Setup menu. |
Other Pages
- Back to VTube-LASER