Difference between revisions of "VTube-LASER - End Scan Diameter Qualification Tolerance"
From ATTWiki
(→How the Tolerance Works) |
(→How the Tolerance Works) |
||
Line 17: | Line 17: | ||
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
− | <td width= | + | <td width=300> |
<br><br> | <br><br> | ||
Line 26: | Line 26: | ||
The tolerance is measured from the out diameter in both directions - both positive (away from the centerline) and negative (toward the centerline).<br><br></td> | The tolerance is measured from the out diameter in both directions - both positive (away from the centerline) and negative (toward the centerline).<br><br></td> | ||
− | <td width= | + | <td width=500> |
− | [[image:VTube-laser-EndScanDiameterQualificationToleranceIllustration.png| | + | [[image:VTube-laser-EndScanDiameterQualificationToleranceIllustration.png|600px]] |
</td> | </td> | ||
</tr> | </tr> |
Revision as of 18:09, 3 May 2016
End Scan Diameter Qualification Tolerance
|
How the Tolerance Works
The End Scan tolerance allows VTube-LASER to control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values. The image illustrates a tolerance of 10 millimeters. Any end scan points within that region will be qualified. See the orange points in image. The red points are outside the tolerance, so they are rejected. |
How to Set the Tolerance
You can set the tolerance in two places in VTube. One place is in the System Options / Measure 2 menu. |
The second place to edit the value is in the VTube-LASER Measure Setup menu's "Other" tab menu. |
Choosing Values
|
Set the Default
Set the default value by clearing the VTube project, then changing the value, then saving the setup to the default file in the System Options - Project Setup menu. |
Other Pages
- Back to VTube-LASER