Difference between revisions of "VTube-LASER - End Scan Diameter Qualification Tolerance"
From ATTWiki
(→How the Tolerance Works) |
(→How the Tolerance Works) |
||
| Line 14: | Line 14: | ||
=== How the Tolerance Works === | === How the Tolerance Works === | ||
| − | |||
<table cellpadding=10> | <table cellpadding=10> | ||
| Line 22: | Line 21: | ||
[[image:VTube-laser-EndScanDiameterQualificationToleranceIllustration.png|500px]]<br><br> | [[image:VTube-laser-EndScanDiameterQualificationToleranceIllustration.png|500px]]<br><br> | ||
| − | The End Scan tolerance | + | The End Scan tolerance allows VTube-LASER to control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values. |
| + | |||
| + | The image above illustrates a tolerance of 10 millimeters. Any end scan points within that region will be qualified. See the orange points in image. The red points are outside the tolerance, so they are rejected.</td> | ||
<td width=300> | <td width=300> | ||
[[image:VTube-LASER-Measure2-EndScanDiameterQualificationTolerance.png|300px]] | [[image:VTube-LASER-Measure2-EndScanDiameterQualificationTolerance.png|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | === How to Set the Tolerance === | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=500> | ||
| + | You can set the tolerance in two places in VTube. One is in the System Options / Measure 2 menu.</td> | ||
| + | <td width=300> | ||
| + | [[image:VTube-LASER-Measure2-EndScanDiameterQualificationTolerance.png|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=500> | ||
| + | The second place to edit the value is in the Measure Setup menu's "Other" tab menu.</td> | ||
| + | <td width=300> | ||
| + | [[image:VTube-LASER-MeasureSetup-EndScanDiameterQualificationTolerance.png|300px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 21:06, 25 September 2013
|
|
|
How the Tolerance Works
|
The End Scan tolerance allows VTube-LASER to control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values. The image above illustrates a tolerance of 10 millimeters. Any end scan points within that region will be qualified. See the orange points in image. The red points are outside the tolerance, so they are rejected. |
|
How to Set the Tolerance
| You can set the tolerance in two places in VTube. One is in the System Options / Measure 2 menu. |
|
| The second place to edit the value is in the Measure Setup menu's "Other" tab menu. |
|
Other End-Scan Information
|
Other Pages
- Back to VTube-LASER
