Difference between revisions of "VTube-LASER - End Scan Diameter Qualification Tolerance"
From ATTWiki
(→How the Tolerance Works) |
(→How the Tolerance Works) |
||
| Line 20: | Line 20: | ||
<td width=500> | <td width=500> | ||
| − | [[image:VTube-laser-EndScanDiameterQualificationToleranceIllustration.png| | + | [[image:VTube-laser-EndScanDiameterQualificationToleranceIllustration.png|500px]]<br><br> |
The End Scan tolerance will control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values.</td> | The End Scan tolerance will control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values.</td> | ||
Revision as of 20:56, 25 September 2013
|
|
|
How the Tolerance Works
|
|
|
Other End-Scan Information
|
Other Pages
- Back to VTube-LASER
