Difference between revisions of "VTube-LASER - End Scan Diameter Qualification Tolerance"
From ATTWiki
(→How the Tolerance Works) |
(→How the Tolerance Works) |
||
Line 19: | Line 19: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=500> | <td width=500> | ||
+ | |||
+ | [[image:VTube-laser-EndScanDiameterQualificationToleranceIllustration.png|400px]]<br><br> | ||
+ | |||
The End Scan tolerance will control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values.</td> | The End Scan tolerance will control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values.</td> | ||
<td width=300> | <td width=300> | ||
− | + | ||
[[image:VTube-LASER-Measure2-EndScanDiameterQualificationTolerance.png|300px]] | [[image:VTube-LASER-Measure2-EndScanDiameterQualificationTolerance.png|300px]] | ||
</td> | </td> |
Revision as of 20:56, 25 September 2013
End Scan Diameter Qualification Tolerance
|
How the Tolerance Works
The End Scan tolerance will control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values. |
Other End-Scan Information
|
Other Pages
- Back to VTube-LASER