Difference between revisions of "VTube-LASER - End Scan Diameter Qualification Tolerance"
From ATTWiki
(Created page with "<table> <tr cellpadding=10> <td width=300> 300px End Scan Diameter Qualification Tolerance<br><br> * Back to VTube-LASER </td> <td width=300...") |
|||
Line 12: | Line 12: | ||
</table> | </table> | ||
__NOTOC__ | __NOTOC__ | ||
+ | |||
+ | === How the Tolerance Works === | ||
Line 19: | Line 21: | ||
The End Scan tolerance will control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values.</td> | The End Scan tolerance will control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values.</td> | ||
<td width=300> | <td width=300> | ||
+ | [[VTube-laser-EndScanDiameterQualificationToleranceIllustration.png|400px]] | ||
[[image:VTube-LASER-Measure2-EndScanDiameterQualificationTolerance.png|300px]] | [[image:VTube-LASER-Measure2-EndScanDiameterQualificationTolerance.png|300px]] | ||
</td> | </td> |
Revision as of 20:55, 25 September 2013
End Scan Diameter Qualification Tolerance
|
How the Tolerance Works
The End Scan tolerance will control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values. |
Other End-Scan Information
|
Other Pages
- Back to VTube-LASER