Difference between revisions of "Teach Mode"

From ATTWiki
Jump to: navigation, search
(Other Pages)
Line 3: Line 3:
 
<td width=300>
 
<td width=300>
  
<font size=4>CNC Bender is ready to LEARN if you're ready to TEACH!</font><br><br>
+
<font size=4>CNC Bender is ready to LEARN when you're ready to TEACH!</font><br><br>
  
 
Teach Mode allows you to Jog any axis or actuator into position while CNC Bender "watches" and remembers your move exactly as you performed it.  Teach the bender your knowledge for difficult transitions between bends.<br><br>
 
Teach Mode allows you to Jog any axis or actuator into position while CNC Bender "watches" and remembers your move exactly as you performed it.  Teach the bender your knowledge for difficult transitions between bends.<br><br>

Revision as of 20:33, 18 January 2010

CNC Bender is ready to LEARN when you're ready to TEACH!

Teach Mode allows you to Jog any axis or actuator into position while CNC Bender "watches" and remembers your move exactly as you performed it. Teach the bender your knowledge for difficult transitions between bends.

The power of Teach Mode shows with its ease-of-use. Actual reactions of new operators prove that this is an easy-to-learn Teach Mode system. (We've been told that our system is one of the easiest to learn and use.) Of course, that translates into time-savings and increased productivity over the long-haul.

  • OVERVIEW of USING TEACH MODE

    • Enable Teach Mode inside the options list for bend 1. (See Screen 1)

    • Power on and Cycle Start the bender

    • Press AUTO mode.

    • Activate the Teach button in the Control Mode bar. (See Screen 2)

    • Load and bend the part

    • After bend 1 is finished, the dies will open, and CNC Bender will enter STEP mode, and display the Teach Mode menu. (See Screen 3)

    • Teach the bender up to 10 Custom Commands - each command can contain any number of simultaneous jog motions. (See Screen 4)

    • Exit the Teach Mode window and finish bending the part.

  • OTHER THINGS TO KNOW

    • Teach in PreBend immediately after you chuck the part and press the run buttons.

    • Control extra moves in PostBend using the final bend's Custom Commands.

    • Three Jog Motion speeds: Fast, Slow, and Fine-tune

    • Absolute values for each axis is shown in the Custom Command Editor in real-time during Teach Mode

    • The distance from goal for each axis is tracked and displayed in real-time during Teach Mode


Screen 1: Enable Teach Mode individually for each bend


Screen 2: New TEACH speed button in the Control Mode bar


Screen 3: Teach Mode activates after a Teach Mode Section was encountered during bending


Screen 4: Custom Command Editor during Teach Mode



Other Pages