Difference between revisions of "Scanning on a NEWPORT type table"
From ATTWiki
(→Reset the Reversed Point Labels) |
(→Potential For Outliers At Normal Relfective Surfaces) |
||
Line 55: | Line 55: | ||
This can cause slight outliers to the laser camera that can cause the cylinder calculation to fail if the cut plane offset is not set large enough.</td> | This can cause slight outliers to the laser camera that can cause the cylinder calculation to fail if the cut plane offset is not set large enough.</td> | ||
<td> | <td> | ||
− | [[image:closeup_newport_outliers_note.png| | + | [[image:closeup_newport_outliers_note.png|600px]] |
</td> | </td> | ||
</tr> | </tr> |
Revision as of 17:04, 13 April 2016
|
NEWPORT Tables
Scanning on NEWPORT tables is possible with the FARO scanner system, but care must be taken because of the high reflectivity of the surfaces in the drilled and tapped holes. | |
Scanning Example
The image on right shows an example of scanning a tube on a Newport table. | |
Potential For Outliers At Normal Relfective Surfaces
View the angle of the scanner in the image in the preceding section. |
|
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page