Difference between revisions of "Reverse the Tube Ends"
From ATTWiki
(→Reverse the Tube Ends) |
(→About Supravision Files) |
||
| Line 33: | Line 33: | ||
<br> | <br> | ||
| − | == | + | == Reversed Point Labels== |
<table> | <table> | ||
| Line 39: | Line 39: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | + | When you reverse the XYZ rows, VTube will also reverse the point labels.<br><br>With the point labels reversed, it is a good idea to look at the END LABELS rather than the POINT LABELS to determine which end to measure first.<br><br> | |
| − | + | See the effect in the image on the right. The END A label is at point 9 in this part after a reverse of the XYZ data.</td> | |
| − | + | ||
| − | + | ||
| − | </td> | + | |
<td> | <td> | ||
| − | [[image: | + | [[image:vtube-laser_2.5_reverse_point_labels.png|400px]] |
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 15:38, 13 April 2016
|
|
|
Reverse the Tube Ends
|
It is often necessary to reverse the tube ends in order to bend the part from the other end of the tube. To reverse the tube ends, you can right click on the XYZ grids for the MASTER or MEASURED data and click on Reverse XYZ Data. |
|
Reversed Point Labels
|
When you reverse the XYZ rows, VTube will also reverse the point labels. |
|
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
