Difference between revisions of "Measuring Square or Rectangular Tube"

From ATTWiki
Jump to: navigation, search
Line 1: Line 1:
ROMER-CIMCORE [[DOCS]] and [[Supravision]] software packages use non-contact infrared probes (sensors) that can measure tube, pipe,  or rod that are bent.  Customers sometimes ask if rectangular or square tube can be measured using the same non-contact sensors.  This is the method recommended by Romer:
+
[[ROMER]] [[DOCS]] and [[Supravision]] software packages use non-contact infrared probes (sensors) that can measure tube, pipe,  or rod that are bent.  Customers sometimes ask if rectangular or square tube can be measured using the same non-contact sensors.  This is the method recommended by Romer:
  
 
==Measuring Center Adapter==
 
==Measuring Center Adapter==
 
[[image:Measuring_center_square_adapter.jpg|right|350px]]
 
[[image:Measuring_center_square_adapter.jpg|right|350px]]
 
In order to simulate a cylindrical shape, it is necessary to change the shape of the square or rectangular tube using an adapter that is designed as shown in this image.
 
In order to simulate a cylindrical shape, it is necessary to change the shape of the square or rectangular tube using an adapter that is designed as shown in this image.

Revision as of 03:07, 25 August 2007

ROMER DOCS and Supravision software packages use non-contact infrared probes (sensors) that can measure tube, pipe, or rod that are bent. Customers sometimes ask if rectangular or square tube can be measured using the same non-contact sensors. This is the method recommended by Romer:

Measuring Center Adapter

Measuring center square adapter.jpg

In order to simulate a cylindrical shape, it is necessary to change the shape of the square or rectangular tube using an adapter that is designed as shown in this image.