Difference between revisions of "Lube Machine At Part Count"

From ATTWiki
Jump to: navigation, search
Line 15: Line 15:
 
Two alternative properties are...  
 
Two alternative properties are...  
  
<l>
+
<ol>
 
<li>Use Bend Count For Machine Lube</li>
 
<li>Use Bend Count For Machine Lube</li>
 
<li>Lube Machine At Bend Count</li>
 
<li>Lube Machine At Bend Count</li>
</l>
+
</ol>
  
  

Revision as of 03:45, 20 July 2006

Contents


What is It?

This property allows CNC Processor to switch the mandrel lube output to ON after a pre-programmed number of parts have run.

Value

The value is set to milliseconds like this:

Lube Machine At Part Count= 500

In this case, the machine lube will activate after each 500 parts run on the machine.

Alternative Properties

Two alternative properties are...

  1. Use Bend Count For Machine Lube
  2. Lube Machine At Bend Count


If Use Bend Count For Machine Lube value is set to 0 then the Lube Machine At Part Count property will be used. Set the Use Bend Count For Machine Lube property to equal 1 to set CNC Processor to use the "Lube Machine At Bend Count" property.

The Lube Machine At Bend Count property is used to set the bend count for machine lube.

--Mcone 23:30, 19 July 2006 (EDT)