Difference between revisions of "How to Ensure Good End Scans in VTube-LASER"
From ATTWiki
(→An Example of a Scan to Reject) |
(→An Example of a Scan to Reject) |
||
Line 88: | Line 88: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
− | This is the result of that scan in VTube-LASER.<td> | + | This is the result of that scan in VTube-LASER.<br><br> |
+ | The end point is not inline with the end wall of the tube.<td> | ||
</td> | </td> | ||
<td> | <td> | ||
− | [[image:VTube-LASER_End_Camera_Stand_Model_Scan.png|500px]] | + | [[image:VTube-LASER_End_Camera_Stand_Model_Scan.png|500px]]<br> |
+ | [[image:VTube-LASER_End_Camera_Stand_Model_Scan_ShouldBe.png|500px]]<br> | ||
</tr> | </tr> | ||
Revision as of 19:19, 7 December 2020
|
Contents |
REPEATABLE END SCANS
Repeatability issues on the ends is the most common problem in GR&R tests. Fortunately it is also the easiest to fix. It involves training users to perform a visual check of the model in the viewport after VTube calculates the end points. |
Use Visual Feedback
In VTube-LASER, operators can use visual feedback to ensure that end point projections are good. This is an example of the the end point projected so that it is in line with the end wall. |
Finding The End Wall
VTube-LASER shows the cloud of points used for the end scan as well as the blue cylinder and the orange end point. |
Visually Align The End Point
The orange end point will always be somewhere along the centerline of the blue cylinder. After the orange end point is projected, an operator can visually confirm that the orange point has been projected along the centerline to the correct location by imagining lines relative to the end scan point cloud like shown in this image. |
An Example of a Scan to Reject
In this case, we put a camera stand near the end of the tube to create an example scan that is not a good one. | ||
This is the result of that scan in VTube-LASER. |
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature