Difference between revisions of "How to Calculate Tube Elongation Percentage in VTube-LASER"
From ATTWiki
(→How to Calculate Tube Elongation Percentage in VTube-LASER) |
(→About Tube Elongation Percentage in VTube-LASER) |
||
Line 13: | Line 13: | ||
__NOTOC__ | __NOTOC__ | ||
− | |||
<table cellpadding=10 width=900> | <table cellpadding=10 width=900> | ||
<tr valign=top> | <tr valign=top> |
Revision as of 14:58, 1 June 2016
|
VTube-LASER can calculate Tube Elongation Percentage by subtracting the current CUT LENGTH from the MEASURED LENGTH - then calculate the percentage by comparing that change to the total ARC LENGTHS in the measured tube. |
How to Calculate Tube Elongation Percentage in VTube-LASER
Any time VTube-LASER has these three conditions it can calculate tube elongation percentage:
If these three conditions are true then you can right click on the Part Setup menu, and use the recalculate tube elongation percentage value. |
Other Pages
- Back to VTube-LASER
- See also Calibration-Leapfrog-Move Targets
- Purchase the targets at the store.