Differences Between VTube License Types
From ATTWiki
|
Levels of Licenses
There are three levels of licenses:
- VTube-STEP
- VTube-LASER Programmer
- VTube-LASER
VTube-STEP imports parts and creates master bender data.
VTube-LASER measures and qualifies parts by connection to a measuring center. VTube-STEP cannot do this. VTube-LASER can also correct benders. VTube-STEP cannot do this.
VTube-LASER Programmer is identical to VTube-LASER, except it cannot connect to a measuring center. It is ideal for VTube-LASER setup.
Differences Between VTube-STEP and VTube-LASER Programmer
- All versions of VTube allow you to import solid models and convert the data to MASTER data.
- All versions allow you to set the default tangent point tolerance.Only VTube-LASER PROGRAMMER (VTLP) allows for complete measuring center setup. Measuring center setup is a section that controls all of the parameters that apply to measuring. If your technicians want complete control over every part of VTube-LASER measuring setup, then VTLP is the way to go.
- VTLP allows technicians to load existing VTube-LASER project files and view Tube Data Storage - which allows for viewing the historical data for all measurements. VTube-STEP cannot do this.
- VTLP can align a measured tube to a master tube. VTube-STEP cannot do this.
- Technicians can setup the Bender Setup screen (choose which bender with which to communicate) in VTLP. VTube-STEP does not have this feature.
- VTLP can recall data from benders. VTube-STEP cannot.
- VTLP is identical to VTube-LASER with the exception that it cannot connect to a measuring center.
- VTLP can build inspection reports. VTube-STEP cannot.
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page