Communications Board for Eaton Leonard - CB-EL1

From ATTWiki
Revision as of 19:22, 18 February 2009 by Mcone (Talk | contribs)

Jump to: navigation, search

CB-EL1 logo.jpg

Contents


Cb-el1 array.jpg


About

This is the Advanced Tubular Technologies communications board designed to communicate with all VELOG, EL-2000, and Premier controls.

  • This board allows us to communicate with any of the three Eaton Leonard bender models using our Benderlink for Eaton Leonard software. This software is used for offline editing of all Eaton Leonard data, storage of Eaton Leonard data, and measuring center communications.

  • We offer this board as a direct replacement to the boards in the Premier controls. (EL-2000 and Velogs have this electronics built-in to the computer boards.)

Vector 1 Laservision Side or Bender Side

  • As of version 2 of this board, the board can be set using jumpers to operate on either side of the connection - either as a BENDER or as a MEASURING CENTER. This means that the board can be used to connect non-Eaton Leonard benders to Laservision using the standard legacy Eaton Leonard protocol.



Current Loop

    The electronic protocol is referred to by Eaton Leonard as "current loop".

    The protocol has been used for several decades and is still one of the standard ports provided on the Eaton Leonard measuring centers.



Features

Cb-el1 render1.jpg

There are several features and improvements in our design of this board:

  1. The board requires only a single +5 volt power (The original design requires both +15 volt, -15 volt, and +5 volt power.)
  2. The simplified electronic design allowed for size reduction to 1/3 original size or the standard EL boards.
  3. This board includes LED indicators: Indicates power, transmission, and reception
  4. This board includes built-in current reversal protection. Reversing the power polarity will not destroy the board.
  5. This board uses screw terminals for power connection
  6. The communications connectors are easy-to-use RJ45 receptacles
  7. The board is certified RoHS compliant (no lead solder)




Communications Modes - LED Activity

The CB-EL1 includes LEDs (Light Emitting Diodes) are that critical for diagnosing issues with systems.

This is how the board appears when a Benderlink package is strobing the RTS and is ready for communications. The RTS LED will flash a couple of times a second.

Cb-el1 running.jpg

This is how the LEDs appear when data is being sent from the Vector to Benderlink. Note that the RX is flashing.

Cb-el1 receiving data.jpg

DataSheets

Advancedtubular eatonleonard currentloop.jpg

Download a Datasheet for the CB-EL1 board

The datasheet contains the information found in this web page.



Purchase

We purchase these in batches - so if you purchase them in quantity, then we can give a batch discount. Of course, we're happy to sell them one at a time. Please contact Mike Cone ([email protected]) for batch-pricing information.