Difference between revisions of "CNC Bender v15.9.5"

From ATTWiki
Jump to: navigation, search
(25px FIXED: Galil Reset Issue)
(25px NEW: Added Jog Motion "End Custom Commands" to Skip Following Custom Commands)
Line 24: Line 24:
 
</td>
 
</td>
 
<td width=600>
 
<td width=600>
[[image:cnc_v15.9.5 End Custom Commands In Editor.png|400px]]
+
[[image:cnc_v15.9.5 End Custom Commands In Editor.png|400px]]<br><br>
 
[[image:cnc_v15.9.5 End Custom Commands Skip All Below.png|400px]]
 
[[image:cnc_v15.9.5 End Custom Commands Skip All Below.png|400px]]
 
</td>
 
</td>

Revision as of 22:40, 14 September 2017

v15.9.5 - September 14, 2017

Cncbender v15 logo.png


Check.jpg NEW: Added Jog Motion "End Custom Commands" to Skip Following Custom Commands

When building Custom Commands, it is helpful to be able to indicate when a Custom Command is the last one in order to save time in the run cycle.

When CNC Bender Processor encounters this command, it skips to the end of that custom command section in the process list.

Cnc v15.9.5 End Custom Commands In Editor.png

Cnc v15.9.5 End Custom Commands Skip All Below.png

Check.jpg FIXED: Window Border Feature

The Window border feature now correctly maximizes the CNC Bender window when the window border is toggled OFF.

Cnc v15.9.5 Toggle Border.png



Check.jpg FIXED: Motion PDA Crash Protection in Manual Absolute

This change is for motion-controlled PDAs.

CNC Bender no longer allows the PDA to move forward to an ABSOLUTE position when the bend arm is positioned less than 90 degrees.

Cnc v15.9.5 PDA Absolute Protect.png




Check.jpg FIXED: Galil Reset Issue

CNC Bender would request a Galil motion controller communications reset on slower computers to often.

This has been resolved.

Galil dmc module.png



Other Pages