CNC Bender v14.7

v14.7 - July 11, 2014 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

ENHANCED: Version 14 Is Now Compatible with Legacy I2T Servo Modules

Version 14 introduced compatibility with the new Galil module. This revision allows version 14 to communicate with legacy I2T modules also.

NEW: "Custom ALL DIES Open" Option

This new option, when enabled, allows the operator to take over the control of how ALL dies open after each bend using CUSTOM COMMANDS.

NEW: "Custom ALL DIES Open" Confirmation and Warning Messages

Prebend confirmation messages and warning messages will display when the new Custom ALL DIES Open option is enabled and AUTOBUILD is run.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands