CNC Bender v12.7

From ATTWiki
Revision as of 04:11, 21 January 2014 by Mcone (Talk | contribs)

Jump to: navigation, search

v12.4 - January 20, 2014

Cncv12procontrol withteachmode.jpg


Check.jpg ENHANCED: Load and Start Positions with Bend Arm Motion Option (in Pre Bend)

CNC Bender Pre Bend has a new option called "Arm to Home Mode" that controls when the bend arm returns home before bending begins. The goal is optimization of the cycle.

These are the choices:

1: Before Move to Load
2: During Move to Load
3: After Move to Load
4: After Chuck Close
5: During Move to Start
6: After Move to Start

Use this in conjunction with the PostBend Release command where you can turn off the bend arm return during release.

Cncbender ArmToHomeInPrebend.png



Check.jpg ENHANCED: Post Bend Release Mode Has a New Mode

A new ninth option is added to the Post Bend Release Modes. This mode can be used with the new Arm to Home Mode to switch off the arm homing at the end of the cycle.

Cncbender autodieswithoutarm.png



Check.jpg Other Changes

  • New COMDEFs were added to work with the new Arm To Home Mode above. The commands are:

Cncbender armtohome commands.png



Other Pages