Difference between revisions of "CNC Bender v12.7"
From ATTWiki
(→25px ENHANCED: Post Bend Release Mode Has a New Mode) |
(→25px ENHANCED: Load and Start Positions with Bend Arm Motion) |
||
| Line 16: | Line 16: | ||
__NOTOC__ | __NOTOC__ | ||
| − | ==[[image:Check.jpg|25px]] ENHANCED: Load and Start Positions with Bend Arm Motion == | + | ==[[image:Check.jpg|25px]] ENHANCED: Load and Start Positions with Bend Arm Motion Option (in Pre Bend)== |
| Line 23: | Line 23: | ||
<tr> | <tr> | ||
<td width=400> | <td width=400> | ||
| − | CNC Bender | + | CNC Bender Pre Bend has a new option called "Arm to Home Mode" that controls when the bend arm returns home before bending begins. The goal is optimization of the cycle. |
<br><br> | <br><br> | ||
These are the choices:<br><br> | These are the choices:<br><br> | ||
Revision as of 04:08, 21 January 2014
v12.4 - January 20, 2014
|
|
ENHANCED: Load and Start Positions with Bend Arm Motion Option (in Pre Bend)
|
CNC Bender Pre Bend has a new option called "Arm to Home Mode" that controls when the bend arm returns home before bending begins. The goal is optimization of the cycle.
1: Before Move to Load |
|
ENHANCED: Post Bend Release Mode Has a New Mode
|
A new ninth option is added to the Post Bend Release Modes. This mode can be used with the new Arm to Home Mode to switch off the arm homing at the end of the cycle.
|
|
Other Changes
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
