CNC Bender v12.1.2

From ATTWiki
Revision as of 19:55, 30 August 2013 by Mcone (Talk | contribs)

Jump to: navigation, search

v12.1.2 - August 30, 2013

Cncv12procontrol withteachmode.jpg



Check.jpg ENHANCED: Motion Recovery Logic

Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.

Old Behavoir

CNC Bender attempts motion-recovery in every mode - even MANUAL mode.

New Behavoir

CNC Bender no longer attempts to recover motion from a pause state (CYCLE HOLD is activated) in these circumstances:

  • When the operator presses any HALT button.
  • The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.
  • The bender has encountered a FAULT condition and motion is stopped.
  • The bender has encountered a command that is timed out and motion is stopped.
  • The E-Stop is pressed and released, and motion is restarted. (This is the same as previous versions.)



Other Pages