Difference between revisions of "CNC Bender v12.1.2"

From ATTWiki
Jump to: navigation, search
(New Behavoir)
(New Behavoir)
Line 30: Line 30:
 
* The bender has encountered a command that is timed out and motion is stopped.
 
* The bender has encountered a command that is timed out and motion is stopped.
 
* The E-Stop is pressed and released, and motion is restarted.
 
* The E-Stop is pressed and released, and motion is restarted.
 +
* When the operator presses any HALT button.
 
<br><br>
 
<br><br>
  

Revision as of 19:54, 30 August 2013

v12.1.2 - August 30, 2013

Cncv12procontrol withteachmode.jpg



Check.jpg ENHANCED: Motion Recovery Logic

Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.

Old Behavoir

CNC Bender attempts motion-recovery in every mode - even MANUAL mode.

New Behavoir

CNC Bender no longer attempts to recover motion from a pause state (CYCLE HOLD is activated) in these circumstances:

  • The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.
  • The bender has encountered a FAULT condition and motion is stopped.
  • The bender has encountered a command that is timed out and motion is stopped.
  • The E-Stop is pressed and released, and motion is restarted.
  • When the operator presses any HALT button.



Other Pages