Difference between revisions of "CNC Bender v12.1.1"
From ATTWiki
(→25px ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision) |
|||
| Line 27: | Line 27: | ||
==[[image:Check.jpg|25px]] ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision== | ==[[image:Check.jpg|25px]] ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision== | ||
| − | Hyprex Laservision | + | CNC Bender Benderlink can emulate the Hyprex Laservision mode which sends 21 characters in the part name rather than 14 characaters.<br><br> |
| + | [[image:cncbender_12.1_benderlink_hyprex.png|400px]] | ||
==[[image:Check.jpg|25px]] Other Changes== | ==[[image:Check.jpg|25px]] Other Changes== | ||
Revision as of 16:34, 14 August 2013
v12.1 - August 14, 2013
|
|
FIX: FRB Clear Part Fixed
CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder.
NEW: Processor Now Checks to See if Inputs are Internal
CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.
FIX: CNC Bender Benderlink Fix with Laservision
CNC Bender Benderlink would sometimes return an out-of-bounds error after receiving Laservision data. This was related to setting the first straight adjustment value to zero. It has been resolved.
ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision
CNC Bender Benderlink can emulate the Hyprex Laservision mode which sends 21 characters in the part name rather than 14 characaters.
Other Changes
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
