Difference between revisions of "CNC Bender v12-20130422"
From ATTWiki
| Line 24: | Line 24: | ||
<td width=400> | <td width=400> | ||
Two COMDEF names are changed from "Boost" to "Assist":<br><br> | Two COMDEF names are changed from "Boost" to "Assist":<br><br> | ||
| − | * "SetPDBoostPressure" to "SetPDAPressure" | + | * "SetPDBoostPressure" to "SetPDAPressure" |
* "SetPDBoostVelocity" to "SetPDAVelocity" | * "SetPDBoostVelocity" to "SetPDAVelocity" | ||
</td> | </td> | ||
| Line 32: | Line 32: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] ENHANCEMENT: Two New Low Level Dynamic Options === | ===[[image:Check.jpg|25px]] ENHANCEMENT: Two New Low Level Dynamic Options === | ||
Revision as of 22:01, 22 April 2013
v12-20130422
|
|
ENHANCEMENT: Change of COMDEF Names
|
Two COMDEF names are changed from "Boost" to "Assist":
|
ENHANCEMENT: Two New Low Level Dynamic Options
|
Two new options are added to better control visibility of buttons on the Manual page |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
