CNC Bender v12-20120830

From ATTWiki
Revision as of 11:18, 30 August 2012 by Mcone (Talk | contribs)

Jump to: navigation, search

v12-20120830

Cncv12procontrol withteachmode.jpg


Check.jpg Enhanced: Autoloader Manual Page Redesign

CNC Bender can now make the TUBE ROTATE and SEAM DETECT buttons invisible. See these two screens:
V12-21020830 autoloader manual expanded.jpg

This next screen shows the two buttons removed from the screen:
V12-21020830 autoloader manual.jpg

Control the visibility of buttons with new low level options:

V12-20120830 panelvisible options.jpg

Check.jpg NEW: Added new Processlists for Autoloader Buttons

Three new process lists were added:

  1. autoloader_home.cncprocesslist
  2. autoloader_liftup.cncprocesslist
  3. autoloader_liftdown.cncprocesslist



These three processlists control the jogging that occurs behind the

  • Autoloader Home button
  • Lift Up button
  • Lift Down button



Rules:

  1. The processlists do not need to exist - however, the buttons in the manual page will do nothing unless commands are inside the processlists.
  2. No block logic is accepted ([IF], etc.) in these processlists.
  3. Parameters are allowed - like "= cto:5000", etc.

Other Pages