CNC Bender v12-20120830

From ATTWiki
Revision as of 11:08, 30 August 2012 by Mcone (Talk | contribs)

Jump to: navigation, search

v12-20120830

Cncv12procontrol withteachmode.jpg


Check.jpg Enhanced: Autoloader Manual Page Redesign

V12-21020830 autoloader manual.jpg
V12-21020830 autoloader manual expanded.jpg


The new design allows for

Check.jpg Enhanced HALT in Processor for Servo Motion

This version implements a stronger HALT in CNC Processor to be sure motion commands are halted during E-Stop. This will ensure that Processor does not continue to move the bender during an E-Stop type event.

Check.jpg Ceased Reporting Error for [BEGIN PROGRAM] Label

When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely.

Check.jpg Ceased Reporting Error for [BEGIN PROGRAM] Label

When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely.


Other Pages