Difference between revisions of "CNC Bender v12-20120629"
| Line 20: | Line 20: | ||
By default, dynamic options should be OFF or in their DEFAULT state when in a Toolbox. | By default, dynamic options should be OFF or in their DEFAULT state when in a Toolbox. | ||
<br><br> | <br><br> | ||
| − | However, the CNC Processlist Builder | + | However, the CNC Processlist Builder improperly tracked if an option was inside the toolbox. This sometimes caused hard-to-trace side-effects where an option seemed to be OUT of the Toolbox to Processlist Builder, but was inside the Toolbox in CNC Bender. Unintended effects could be as serious as skipping bends for example. |
<br><br> | <br><br> | ||
This version fixes this issue by allowing both CNC Bender, CNC Processlist Builder and CNC Processor to track if the operator has placed the option in the Toolbox based on which operator station the part is running in. | This version fixes this issue by allowing both CNC Bender, CNC Processlist Builder and CNC Processor to track if the operator has placed the option in the Toolbox based on which operator station the part is running in. | ||
Revision as of 00:45, 30 June 2012
v12-20120629
|
|
Repair - Default Option Values in the Toolbox Now Switched Off
|
By default, dynamic options should be OFF or in their DEFAULT state when in a Toolbox.
|
Repair - Robot Clear Bit Can Be High or Low
|
The Robot Clear bit always assumed that the TRUE signal was bit high. But some machines assume the opposite. This has been fixed.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
