Difference between revisions of "CNC Bender v12-20120629"
| Line 13: | Line 13: | ||
</table> | </table> | ||
__NOTOC__ | __NOTOC__ | ||
| − | ===[[image:Check.jpg|25px]] Repair - | + | ===[[image:Check.jpg|25px]] Repair - Default Option Values in the Toolbox Now Switched Off=== |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| − | + | By default, dynamic options are OFF, or in their default state when in a Toolbox.<br><br> | |
| − | <br> | + | |
| + | However, the CNC Processlist Builder had difficulty determining if an option was inside the toolbox - even if it was inside the toolbox in CNC Bender. This sometimes caused hard-to-trace side-effects where an option seemed to be active - and causing unintended effects like skipping bends, or calling out to features that were placed in the toolbox. | ||
| + | <br><br> | ||
| + | This version fixes this issue by allowing both CNC Bender, CNC Processlist Builder and CNC Processor to track if the operator has placed the option in the Toolbox based on which operator station the part is running in. | ||
</td> | </td> | ||
| Line 28: | Line 31: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
===[[image:Check.jpg|25px]] Repair - Robot Clear Bit Can Be High or Low=== | ===[[image:Check.jpg|25px]] Repair - Robot Clear Bit Can Be High or Low=== | ||
Revision as of 00:43, 30 June 2012
v12-20120629
|
|
Repair - Default Option Values in the Toolbox Now Switched Off
|
By default, dynamic options are OFF, or in their default state when in a Toolbox. However, the CNC Processlist Builder had difficulty determining if an option was inside the toolbox - even if it was inside the toolbox in CNC Bender. This sometimes caused hard-to-trace side-effects where an option seemed to be active - and causing unintended effects like skipping bends, or calling out to features that were placed in the toolbox.
|
Repair - Robot Clear Bit Can Be High or Low
|
The Robot Clear bit always assumed that the TRUE signal was bit high. But some machines assume the opposite. This has been fixed.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
