CNC Bender v12-20111229

From ATTWiki
Revision as of 18:00, 29 December 2011 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

v12-20111229

Cncv12procontrol withteachmode.jpg

Check.jpg REPAIR - Pressure Die Interference Zone

  • The pressure die interference logic would stop the bending with a collision fault if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.
  • This has been resolved with this version. If the PDA is a servo axis, then the potential for collision is ignored.



</table>

Check.jpg Other

Other Pages