Difference between revisions of "CNC Bender v12-20111229"

From ATTWiki
Jump to: navigation, search
(→‎25px REPAIR - Pressure Die Interference Zone Collision Logic Change)
(→‎25px REPAIR - Pressure Die Interference Zone Collision Logic Change)
 
Line 31: Line 31:
 
</tr>
 
</tr>
 
</table>
 
</table>
 +
<br><br>
  
 
=Other Pages=
 
=Other Pages=

Latest revision as of 18:56, 29 December 2011

v12-20111229

Cncv12procontrol withteachmode.jpg

Check.jpg REPAIR - Pressure Die Interference Zone Collision Logic Change

  • THE ISSUE
    The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.


  • THE REPAIRED LOGIC
    Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored . This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm.




Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12-20111229&oldid=17366"