Difference between revisions of "CNC Bender v12-20111229"

From ATTWiki
Jump to: navigation, search
(25px REPAIR - Pressure Die Interference Zone Collision Logic Change)
(25px REPAIR - Pressure Die Interference Zone Collision Logic Change)
 
(6 intermediate revisions by one user not shown)
Line 18: Line 18:
 
<tr valign=top>
 
<tr valign=top>
 
<td width=400>
 
<td width=400>
* ISSUE RESOLVED: The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.
+
* '''THE ISSUE'''<br>The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.
 
<br>
 
<br>
* RESOLUTION: Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored .  This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm.
+
* '''THE REPAIRED LOGIC'''<br>Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored .  This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm.
<br>
+
 
* Note that it is possible for a collision to still occur if the radius value is set incorrectly in the tool page, or the real-time variable gearing for the PDA is set low enough to allow the carriage to catch up to the PDA.
+
 
</td>
 
</td>
  
Line 32: Line 31:
 
</tr>
 
</tr>
 
</table>
 
</table>
 +
<br><br>
  
 
=Other Pages=
 
=Other Pages=

Latest revision as of 18:56, 29 December 2011

v12-20111229

Cncv12procontrol withteachmode.jpg

Check.jpg REPAIR - Pressure Die Interference Zone Collision Logic Change

  • THE ISSUE
    The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.


  • THE REPAIRED LOGIC
    Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored . This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm.




Other Pages