Revision as of 21:40, 30 November 2011

v12-20111120

The PDA gearing is now properly set if the VG (Realtime Variable Gearing) feature is off or on.
The PDA returns home when the operator presses All Dies Home.

The Tube Support now stays DOWN during homing when the tube support UP enable feature is disabled.

This command is used by the process list builder to enable the Feed axis even when the axis list is setup to only enable when moving. This ensures that the Feed axes with low gearbox ratios stay in position when loading the tube.

@@ Line 35: / Line 35: @@
 <td width=400>
 * The Tube Support now stays DOWN during homing when the tube support UP enable feature is disabled.<br><br>
+</td>
+<td width=300>
+</td>
+</tr>
+</table>
+===[[image:Check.jpg|25px]] New - [Enable Axis] Internal Command  ===
+<table cellpadding=10>
+<tr valign=top>
+<td width=400>
+* This command is used by the process list builder to enable the Feed axis even when the axis list is setup to only enable when moving.  This ensures that the Feed axes with low gearbox ratios stay in position when loading the tube.<br><br>
 </td>