Difference between revisions of "CNC Bender v12-20111120"
From ATTWiki
| (5 intermediate revisions by one user not shown) | |||
| Line 18: | Line 18: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| − | * The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE.<br> | + | * The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE.<br><br> |
| − | * | + | * This is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp".<br><br> |
</td> | </td> | ||
| Line 29: | Line 29: | ||
</table> | </table> | ||
| + | ===[[image:Check.jpg|25px]] FIX - XYZ to FRB Calculation Linear Units Issue === | ||
| − | + | [[image:xyz_tool_bar.jpg|500px]] | |
| − | + | ||
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| − | * The XYZ to FRB calculation now | + | * The XYZ to FRB calculation now properly handles the linear units when converting.<br><br> |
| − | * The XYZ to FRB calculation now | + | * The XYZ to FRB calculation now uses the default configuration to preset the FRB row options.<br><br> |
</td> | </td> | ||
Latest revision as of 04:30, 21 November 2011
v12-20111120
|
|
CHANGE - Extra Horizontal Clamp Close
|
FIX - XYZ to FRB Calculation Linear Units Issue
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
