Difference between revisions of "CNC Bender v12-20111103"

From ATTWiki
Jump to: navigation, search
 
(25px FIX - High Speed Timer)
 
(One intermediate revision by one user not shown)
Line 18: Line 18:
 
<tr valign=top>
 
<tr valign=top>
 
<td width=400>
 
<td width=400>
A high speed timer in CNC Processor was adjusted so that it would run properly with thread synchronization to prevent access errors.<br><br>
+
A high speed timer in CNC Processor was adjusted so that it will run properly with thread synchronization to prevent potential access errors.<br><br>
 
</td>
 
</td>
  
 
<td width=300>
 
<td width=300>
</td>
 
 
 
</tr>
 
</table>
 
 
===[[image:Check.jpg|25px]] NEW - "Pulse Enable At Halt" in Axis List Setup  ===
 
 
<table cellpadding=10>
 
<tr valign=top>
 
<td width=400>
 
"Pulse Enable At Halt=" is a new parameter in the axis list configuration.<br><br>
 
 
This allows you to setup CNC Bender to always pulse the enable of an axis during the HALT command.<br><br>
 
 
This makes the axis super safe because it always clears all following error.
 
</td>
 
 
<td width=300>
 
The default value is "1" which means "true" or "enabled."  Use 0 to switch this feature off.
 
</td>
 
 
 
</tr>
 
</table>
 
 
===[[image:Check.jpg|25px]] NEW - "Enable Only To Move" in Axis List Setup  ===
 
 
<table cellpadding=10>
 
<tr valign=top>
 
<td width=400>
 
"Enable Only To Move=" is a new parameter in the axis list configuration.<br><br>
 
 
This allows you to setup CNC Bender to enable axes only when in motion.<br><br>
 
 
</td>
 
 
<td width=300>
 
The default value is "0" which means "disabled."  Use 1 to switch this feature on.
 
 
</td>
 
</td>
  

Latest revision as of 01:42, 4 November 2011

v12-20111103

Cncv12procontrol withteachmode.jpg

Check.jpg FIX - High Speed Timer

A high speed timer in CNC Processor was adjusted so that it will run properly with thread synchronization to prevent potential access errors.

Other Pages