Revision as of 02:19, 1 November 2011

v12-20111101

"Pulse Enable At Halt=" is a new parameter in the axis list configuration.

This allows you to setup CNC Bender to always pulse the enable of an axis during the HALT command.

This makes the axis super safe because it always clears all following error.

The default value is "1" which means "true" or "enabled." Use 0 to switch this feature off.

"Enable Only To Move=" is a new parameter in the axis list configuration.

This allows you to setup CNC Bender to enable axes only when in motion.

The default value is "0" which means "disabled." Use 1 to switch this feature on.

@@ Line 13: / Line 13: @@
 </table>
 __NOTOC__
-===[[image:Check.jpg|25px]] NEW - Axis List Setup Parameter: Pulse Enable At Halt  ===
+===[[image:Check.jpg|25px]] NEW - Pulse Enable At Halt in Axis List Setup  ===
 <table cellpadding=10>
@@ Line 27: / Line 27: @@
 <td>
 The default value is "1" which means "true" or "enabled."  Use 0 to switch this feature off.
+</td>
+</tr>
+</table>
+===[[image:Check.jpg|25px]] NEW - "Enable Only To Move" in Axis List Setup  ===
+<table cellpadding=10>
+<tr valign=top>
+<td width=400>
+"Enable Only To Move=" is a new parameter in the axis list configuration.<br><br>
+This allows you to setup CNC Bender to enable axes only when in motion.<br><br>
+</td>
+<td>
+The default value is "0" which means "disabled."  Use 1 to switch this feature on.
 </td>