CNC Bender v12-20110525

From ATTWiki
Revision as of 02:33, 26 May 2011 by Mcone (Talk | contribs)

Jump to: navigation, search

v12-20110525

Cncv12procontrol withteachmode.jpg



Check.jpg ENHANCED - Changes

  • Chuck Close/Open Skip in Post Bend - for special teach mode unloading

  • Processor checks for special internal command

[BEGIN RUN AGAIN] in processlists - which is required even in custom processlists.

  • Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed.



Check.jpg NEW - SmartInspect Configuration File Added

A new configuration file "loggingsetup.cfg" is added to the cnc\config folder.

The new logging setup allows for debug logging in both CNC Processor and CNC Bender.

The logging setup features for CNC Processor were previously in the CNCProcessor.cfg file.

Logginsetup file.jpg



Other Pages