Difference between revisions of "CNC Bender v12-20110308"

From ATTWiki
Jump to: navigation, search
(25px NEW - STEP Mode only)
(25px NEW - STEP Mode only)
 
(One intermediate revision by one user not shown)
Line 15: Line 15:
 
__NOTOC__
 
__NOTOC__
  
===[[image:Check.jpg|25px]] NEW - STEP Mode only  ===
 
  
<table cellpadding=10>
 
<tr valign=top>
 
<td width=400>
 
A new STEP Mode only option is available in low level.  When enabled, CNC Bender will only run in STEP mode.<br>
 
</td>
 
 
<td>
 
</td>
 
 
</tr>
 
</table>
 
  
===[[image:Check.jpg|25px]] NEW - "Lost Home" Tolerance  ===
+
===[[image:Check.jpg|25px]] NEW - "Lost Home" Tolerance Increased ===
  
 
<table cellpadding=10>
 
<table cellpadding=10>
 
<tr valign=top>
 
<tr valign=top>
 
<td width=400>
 
<td width=400>
 +
CNC Processor previously had zero tolerance for a HOME state that switches to OFF then back ON again quickly.<br><br>
 
CNC Processor will now recheck for a lost home state up to 25 times before switching the motor off and issuing a fault.<br>
 
CNC Processor will now recheck for a lost home state up to 25 times before switching the motor off and issuing a fault.<br>
 
</td>
 
</td>

Latest revision as of 18:08, 24 March 2011

v12-20110308

Cncv12procontrol withteachmode.jpg



Check.jpg NEW - "Lost Home" Tolerance Increased

CNC Processor previously had zero tolerance for a HOME state that switches to OFF then back ON again quickly.

CNC Processor will now recheck for a lost home state up to 25 times before switching the motor off and issuing a fault.



Other Pages