CNC Bender v12-20101223

From ATTWiki
Revision as of 20:26, 25 December 2010 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Cncv12procontrol withteachmode.jpg

Contents



Check.jpg REDESIGNED - Run Page

The Run Page is redesigned so that the next step is a very large message.

The Step List is removed from this page as it is too much information for some users.

Runpage large nextstep.jpg

Check.jpg NEW - New Diagnostic Tab Menu

A new diagnostic tab menu contains the Step List that was previously on the Run Page.

This list allows operators to view the steps the bender is performing in realtime.

Runpage diagnostic steplist.jpg

Other Pages