CNC Bender v12-20101021

From ATTWiki
Revision as of 20:05, 22 October 2010 by Mcone (Talk | contribs)

Jump to: navigation, search

Cncv12procontrol withteachmode.jpg

Contents


Check.jpg NEW - Added Input Timer in PreEnable

Schneider Lexium drives require a pulse to switch from READY to RUN mode. This feature was added to allow for pulsing Lexium drives a specific amount of time before the axes were enabled.

Lexium drive motor.jpg

Check.jpg FIXED - Early Mandrel Extra On Last Bend

For benders with motion controlled PDA, the early mandrel extract did not work on the last bend.

This has been repaired so that the feature works.

Ball mandrel.jpg
(Image from Tools For Bending web site)

Check.jpg NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT

The FEED TORQUE is now set to ZERO% during mandrel retractions. This prevents possible destruction of the FEED gearbox, rack, pinion, chain, if the tube breaks during bending and the mandrel pulls the tube and carriage back.

Other Pages