CNC Bender v12-20101021

NEW - Added Input Timer in PreEnable

Schneider Lexium drives require a pulse to switch from READY to RUN mode. This feature was added to allow for pulsing Lexium drives a specific amount of time before the axes were enabled.

FIXED - Early Mandrel Extra On Last Bend

For benders with motion controlled PDA, the early mandrel extract did not work on the last bend. This has been repaired so that the feature works.

NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT

The FEED TORQUE is now set to ZERO% during mandrel retractions. This prevents possible destruction of the FEED gearbox, rack, pinion, chain, if the tube breaks during bending and the mandrel pulls the tube and carriage back.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands