Difference between revisions of "CNC Bender v12-20101005"
From ATTWiki
| Line 47: | Line 47: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=200> | <td width=200> | ||
| − | The FEED TORQUE is always set to ZERO% during mandrel retractions. | + | The FEED TORQUE is always set to ZERO% during mandrel retractions. This prevents possible destruction of the FEED gearbox, rack, pinion, chain, if the tube breaks during bending and the mandrel pulls the tube and carriage back. |
</td> | </td> | ||
<td> | <td> | ||
Revision as of 13:46, 7 October 2010
|
|
Contents |
NEW - LOAD and START in RUN PAGE
|
The LOAD and START values can now be programmed in the RUN PAGE. |
NEW - FEED AXIS POSITION DISPLAY FROM BACK OR FRONT
|
The FEED axis values can be displayed from the front or the back by pressing a toggle button in the RUN PAGE. |
NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT
|
The FEED TORQUE is always set to ZERO% during mandrel retractions. This prevents possible destruction of the FEED gearbox, rack, pinion, chain, if the tube breaks during bending and the mandrel pulls the tube and carriage back. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
