Difference between revisions of "CNC Bender v12-20100903"

From ATTWiki
Jump to: navigation, search
(25px NEW - Added Speed Ramp-Down for Direct Axis Jogging)
(25px ENHANCED - Added CNC Processor Automatic High Pressure Handling)
Line 107: Line 107:
 
</td>
 
</td>
  
 
+
</tr>
 
+
</table>
  
 
===[[image:Check.jpg|25px]] NEW - Added Speed Ramp-Down for Direct Axis Jogging  ===
 
===[[image:Check.jpg|25px]] NEW - Added Speed Ramp-Down for Direct Axis Jogging  ===

Revision as of 23:27, 31 August 2010

Cncv12procontrol withteachmode.jpg



Check.jpg NEW - CYCLE HOLD in Custom Commands and in TEACH Mode

Now CYCLE HOLD anywhere inside a CUSTOM COMMAND either manually entered or taught during TEACH MODE.

Cycle Hold pauses the process perpetually until Cycle Start is pressed.

See also the Cycle Hold button.

Cncbender customcommand cyclehold.jpg

Check.jpg ENHANCED - ENABLE Button for STEP and AUTO Modes

The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode

When this feature is enabled, then the ENABLE button must be pressed or a large message will display indicating that the operator must press the ENABLE button

Cncbender pressenable to switch to autostep.jpg

Check.jpg ENHANCED - Vertical Head Shift Tolerance Added

The vertical head shift tolerance allows us to skip motion when an axis is close enough to the final position.

The tolerance value is now present in the Low Level General Options list and is used by the processlist compiler to give the Processor more efficient processlists.

Cncbender vertical head shift tolerance options.jpg


Check.jpg ENHANCED - Added CNC Processor Automatic High Pressure Handling

CNC Processor now uses the CIO Name Cross Reference in the Low Level menu to automatically set the high pressure under these two special circumstances:

  • Just before CNC Processor performs a direct axis jog, CNC Processor sets the CIO point for high pressure.

  • When CNC Processor switches from Cycle Hold to Cycle Start, CNC Processor sets the CIO point for high pressure.


Hydraulic pressure gauge.jpg

CIONamesCrossReference.jpg

Check.jpg NEW - Added Speed Ramp-Down for Direct Axis Jogging

This new feature allows any axis to be direct-axis jogged using a joystick, pendant, or screen buttons with the assurance that the jogging motion will not exceed the soft EOT (End of Travel) limits feature added in the prevision revision.



Hydraulic pressure gauge.jpg

CIONamesCrossReference.jpg

Other Pages