CNC Bender v12-20100707

From ATTWiki
Revision as of 00:56, 8 July 2010 by Mcone (Talk | contribs)

Jump to: navigation, search

Cncv12procontrol withteachmode.jpg



Check.jpg ENHANCED - All Output Modules Now Use Extended Sustain Time

The sustain time is used to control how long the output modules stay on around the CNC Bender system even if they are not being serviced.

The time is setup in the Processor tab of the low level menu, and was previously applied only to the first output module.

Now it is applied to all the output modules throughout the entire system.

Modicon on din.jpg

Other Pages