CNC Bender v12-20100611

From ATTWiki
Revision as of 15:06, 14 June 2010 by Mcone (Talk | contribs)

Jump to: navigation, search

Cncv12procontrol withteachmode.jpg
Teachmodejoystick.jpg



Check.jpg NEW - CNC Bender Direct-Axis Jog with Joystick or Pendant

CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging.

Direct axis jogs using external devices is active in the MANUAL and TEACH MODE pages.

In the MANUAL page, the joystick or pendant is used only when the Direct Axis jog button is activated.

In the CUSTOM COMMAND EDITOR page, the joystick or pendant is used only when the TEACH button is activated.

In the CUSTOM COMMAND EDITOR in TEACH mode, the joystick and teach-pendant can control both SERVO and DIRECTIONAL-VALVE actuators. In other words - they can control all actuators.

Joystick.jpg
Euchnerpendant.jpg

Check.jpg NEW- Setup Options for Direct Axis Jog from INPUTS

The low level general options list contains three new options:

  • ENABLE
  • JOG+ Input Name
  • JOG- Input Name



If this feature is enabled, then the input names are used to lookup the input points in the CIO dictionary.

Other Pages