CNC Bender v12-20100105

From ATTWiki
Revision as of 16:33, 18 January 2010 by Mcone (Talk | contribs)

Jump to: navigation, search

Cncbender logo.jpg

Type of Upgrade: MAJOR VERSION CHANGE with Teach Mode

The changes in this version take CNC Bender to the next step in setup power: TEACH your bender how to solve problems.

The new v12 main menu in CNC Bender ProControl

Contents



Check.jpg NEW - TEACH MODE

New TEACH speed button in the Control Mode bar


  • CNC Bender can now learn from you during setup. Teach the bender any motion for difficult transitions between bends

  • The learned moves are held in objects called Custom Commands (see more below).

  • PreBend allows for 10 Custom Commands. They run immediately after you press the run buttons.

  • Each BEND can be followed by up to 10 Custom Commands.

  • Control extra moves in PostBend using the final bend's Custom Commands.

Teach Mode activates after a Teach Mode Section was encountered during bending


Custom Command Editor during Teach Mode


Cncb12frb customcommands button.jpg


FRB menu with Edit Custom buttons after each bend




Check.jpg NEW - TEACH MODE and CUSTOM COMMANDS

  • CNC Bender can now learn from you during setup. Teach the bender any motion for difficult transitions between bends

  • The learned moves are held in objects called Custom Commands.

  • PreBend allows for 10 Custom Commands. They run immediately after you press the run buttons.

  • Each BEND can be followed by up to 10 Custom Commands.

  • Control extra moves in PostBend using the final bend's Custom Commands.

  • Each Custom Command can contain any number of simultaneous Jog Motions. In a SINGLE Custom Command, you could teach the bender how to move the...
    • FEED (carriage)
    • while ROTATING
    • while shifting the VERTICAL RADIUS
    • while shifting the HORIZONTAL RADIUS
    • while returning the BEND ARM
    • while pulling the MANDREL
    • while activating the KICKER
    • while doing anything else you can make move on the bender

  • So Custom Commands can control all axes and actuators around the bender including directional valves - clamp, pressure die, kickers, grippers, mandrel, mist, machine lube - ANY ACTUATOR.

  • Custom Commands can be MANUALLY entered and edited. You can enter Custom Commands without Teach Mode.

  • Custom Commands can be edited even after they were learned during Teach Mode.

New TEACH speed button in the Control Mode bar
Teach Mode activates after a Teach Mode Section was encountered during bending


Custom Command Editor during Teach Mode


Cncb12frb customcommands button.jpg


FRB menu with Edit Custom buttons after each bend




Other Pages